Common Ceiling Problems We Fix
Water damage and leak stains
Roof leaks, pipe leaks, overflowing upstairs bathrooms, flood and water damage. We assess the drywall, cut out anything that is soft, stained or compromised, replace it with new drywall, tape and finish. A stain-blocking primer is applied so the old stain does not bleed through the final coat.
Cracks – hairline, corner and recurring
Settlement cracks, seasonal cracks from Northern Ontario temperature swings, old plaster cracks that have been painted over three times already. We use mesh tape and flexible compound to absorb movement so the fix stays put.
Holes after HVAC and vent installation
Ducting, bath fans, range hoods, HRV systems – after the installer leaves, the ceiling usually has openings that need clean patching. We cut square, install a proper backer, drywall piece, tape, mud, sand and prime.
Patches after plumbers
Pipe access cuts, shower valve rough-ins, leak repairs, drain line replacements. Plumbers leave access holes – we close them so the ceiling looks like nothing ever happened.
Patches after electricians
Pot light installation, ceiling fan wiring, junction box moves, smoke detector rewiring. Clean patches around fixtures and between openings, finished smooth so paint blends in without halos.
Flood and water damage restoration
Full-ceiling failure after a major leak or overflow: sagging drywall, blown tape joints, stained insulation, peeling paint. We remove what is damaged, replace it, and restore the ceiling to a paint-ready finish. If insulation was affected, we flag it so it can be replaced before the drywall goes back up.
Popcorn (stipple) ceiling removal
Scrape-off, skim coat to a smooth surface, prime and paint. Plastic and dust containment is set up before work starts so the mess stays in one room. In homes built before 1980, we recommend a third-party asbestos test before removal – that is a safety issue we will not cut corners on.
Sagging drywall
If your ceiling drywall has dropped, lost its anchor to the joists, or developed soft spots after humidity or water exposure, we secure or replace it and refinish the surface.
Redoing bad previous repairs
Patches that show through the paint, mismatched texture, blown-out feather lines, obvious bumps. We strip back the bad work, re-skim the area wider than the original patch and finish it properly.